Home
About Us
Catalog
  Order Form
Contact Us
Customer Support
Information
Measuring Your Bore
Selecting A Bullet Style
Sizing & Lubing
Products
Premium Molds
Bullet Lube
Hardness Tester
Books
LBT HIGH PERFORMANCE BULLET LUBRICANTS

See the page, "Information on Sizing and Lubing", for more info about selecting the proper lube.

All three hardnesses have the same performance characteristics, which are unequaled by any other lubricant. Due to superior control of friction, which is the cause of leading, LBT lubricants produce less pressure than any other cast bullet lubricant, accompanied by higher velocity capabilities. Rifles can be loaded to 3,000 fps without bore leading. Magnum handguns absolutely will not lead with gas checked bullets, and fdPB can be loaded to 1800 fps without leading in cool weather. Velocities of 1400 fps can be achieved at high ambient temperatures, which are the worst conditions for shooting lead. Typically, handguns will produce 300 fps more speed than with jacketed of equal weight, if one of our LBT bullet designs is used. This is in handguns only. Rifles tend to give very close to jacketed speeds with equal bullet weights and powder charges. One of the most attractive properties of LBT lubricants which no other can offer is: If you lead your bore from a crazy load or getting the gun too hot, etc., let it cool down or go back to a load that doesn’t lead and shoot 2 or 3 gas checked rounds, or 5 or so if plain based, and the lead will be gone. If you’re leaded up from some other lubricant, LBT with gas checked bullets will clean it out far quicker than shooting jacketed, but not with plain based. Lead actually solders to the bore with other lubes. With LBT lubes, IF you can make it lead, it’s so loose that more shooting will wipe it clean! We recommend never cleaning the bore when LBT lubes are used. Look down the bore and if there is lead, shoot it out, if not, DON’T CLEAN IT!

Very few people who have tried our lubricants will use anything else.

LBT BLUE

 Flows thru most lubers at room temp without heat if the lube grooves are large. Some heat is needed if grooves are small or temps are lower, especially with Lyman sizers.

LBT BLUE SOFT

Our most popular lube. We believe this is our most popular lube, mainly because it flows in almost any temperature and yet is less effected by real high heat than any of the three. For example, if ammo is left on a vehicle dash in the blazing sun, this lube won’t migrate into the powder and kill it as most competitive lubes do. Our other two are real good compared to competitive lubes, but soft is our best, staying where it belongs when heated day after day at up to 200 deg! (For Star sizers  do not apply the full lube pressure to the lube screw in warm temperatures or it will leave a streak of lube across the bullet. Alox and many other will do the same.)

LBT COMMERCIAL

This is our hardest, and will require heat for application, or 100 deg F ambient temperatures. It runs nicely through most lubers with heaters running at around 100 to 120 deg F. Commercial casters prefer it because it stays on boxed bullets best during shipping.

10 sticks - $35.00 Shipping $8.00 to any US address.

30 sticks - $85.00 Shipping $10.00 to any US address.




Ⓒ 2014 Lead Bullets Technology
All Rights Reserved
Questions or Comments